YOU ARE HERE:
Help - Digital Cable > FAQ - Digital Cable > Set-Top Box/Remote Control > Program Your Remote > Remote Codes for your 3 Device >
Programming your Remote for your TV/VCR combination
| Note: some TV/VCR combinations may require a second TV code to control volume. Check the codes below and follow the instructions in Programming for your TV using the supplied TV code. If there is no TV code listed for your TV/VCR combo's operating code, you will need to use the volume control capabilities of your cable terminal. 1. Click on the arrow below to find and highlight your TV/VCR manufacturer from the pull-down menu. 2. On the remote control, press the device key (i.e. TV, VCR or AUX) once. Press and hold SETUP until the selected mode key blinks twice, then release. 3. Now enter the four-digit code listed below: Many devices have more than one code listed. For these, start with the first code. If that doesn't work, try the second and so on. The TV/VCR's indicator should flash three times. If it doesn't, press AUX as described above and try again with the next code. For example, if you have a Radio Shack TV/VCR, press AUX, then hold SETUP until the AUX light flashes twice, then press 0-0-3-7. 4. After you have entered the correct code, point the remote at your TV/VCR and press POWER. If your TV/VCR turns on or off, you are finished programming for your TV/VCR. If you have tried all the codes listed for your TV/VCR and it still does not turn on or off, click here. | ||
